Removing and Filling Old Dynabolt Holes.
This week, we tackled a site where dozens of old dynabolts needed removing. Some came straight out, while others were sheared off and needed drilling. Once they were out, we filled the holes with epoxy resin, leaving the concrete as good as new. It’s a straightforward job, but one that keeps floors safe and looking clean.
Surface Grinding for a Clean Finish
Surface Grinding for a Clean Finish. After some core drilling work, we moved on to surface grinding to even out rough patches left behind from old fittings. It’s one of those jobs that makes a big difference but often goes unnoticed—smoothing out the surface so new...
Removing Old Floor Anchors
Removing Old Floor Anchors. We spent the day pulling out old floor anchors from a warehouse site. Some came out easy, while others needed a bit of grinding and drilling to remove properly. It’s always satisfying to leave a clean surface behind, ready for new...
Precision Core Drilling on Site
Precision Core Drilling on Site. Today’s job involved drilling multiple core holes through a thick concrete floor for new service installations. The drill setup was simple—mark, drill, extract, repeat. With reinforced concrete, precision and the right tools make all...
Core Drilling & Filling – Another Day on Site
Core Drilling & Filling – Another Day on Site. Here’s a look at a recent core drilling job, cutting precise holes through a concrete slab to make way for new fixtures. Using a diamond-tipped core drill, we worked through reinforced concrete with minimal mess and...